How to Change, Upgade or Remove an IDE Hard Drive

Hard Disk Drives - hard drives are a bit more complicated. First, you need to know what you want to take the hard drive. For that, I think, if you want either to establish or slave master. If you want to start from the hard disk (for Windows or another operating system outside of it) and want to be your teacher. If you already have a master, and you want to use this place as another, the HDD a slave. The amendment requires the establishment of a bridge at the rear of the hard disk to be transferred. It's hard May, it is also very simple. These configurations bridge is located on the rear of the hard drive, most of them have a small label that says it is. After setting up the bridge, take the IDE cable that goes to your first hard disk. It's time, usually gray cable which runs from space on the motherboard and the main hard disk. If you set the new hard drive as a slave, the cable should have a new contact in it is not used. En route to the new hard drive slave, but not connect the cable second hard drive. If you put a new impetus as captain, you must cable directly to your old hard drive, separating and connecting the new hard drive teacher. In both cases, to attach a cord on the hard drive. It is food, and you need to have a couple of not being used. Please include a contact for connecting 4 roads in the hard disk. When the drive is connected, you'll need to make sure it is linked to the chassis on both sides of the issue. This can be done by removing the cause, and then change the hard disk on the one hand, and then another. This is important - if only the bolt on one side of the disk, it can cause damage to files on your hard drive. I am a young, aspiring computer engineer in Internet marketing, equipment, software, web design, SEO and everything related to computers. Come before leaving my system increasingly forum http://www.markspcforum.com http://www.markspcforum.com